|
The Bergen R/C Helicopters Twin Observer is a dedicated Camera Ship. Based on our popular Intrepid Gas mechanics, the reliable Zenoah/Bergen G52 engine, and 810 mm V-Blades, we have added a front mounted pan and tilt system to give you a machine capable of lifting up to 20 lb useful payload of camera equipment and radio gear. The camera mount can handle up to 8 Lbs, with the additional payload needing to be located so as to maintain CG. The dimensions of the camera mount allow a camera up to 5 7/8" wide, 6 " tall, and 12" long.
Putting the camera equipment on the front keeps you from having to utilize a tall landing gear and the inherent problems associated with it. A front mounted camera also allows you a clear 270 degree field of view, and the pan and tilt system is vibration isolated from the mechanics with 4 heavy -duty isolators to give you the clearest picture possible.
The Twin Observer uses G10 stacked frames and a torque tube drive on the tail. It also comes with all the standard features from the Intrepid line of helicopters, including a self aligning clutch system with a factory installed clutch liner, a triple bearing block supporting the drive pinion and start shaft, a 10mm fully hardened hollow main shaft, an all aluminum head and blade grips, and an aluminum push-pull control system designed to eliminate any swash plate interaction through the full range of travel. The 32 oz. fuel tank provides a flying time of approximately 30 minutes. Additional fuel tanks can be added in a saddle configuration for extended flighttimes of 2 hours or more. Of course this reduces your total payload capability.
The Twin Observer comes pre-assembled and test flown from the factory. It is NOT available as a kit, Only minor assembly is necessary after you receive the helicopter. We will install and use your radio gear for the test flights.
Listed below are five of our most popular purchase packages and some additional options.
TERMS OF PURCHASE:
The total cost of all radio gear and optional parts to be purchased must accompany the initial order. We also require a minimum deposit of $1500 to begin the building process. The remaining balance plus shipping and handling fees are due at time of shipment.
Please Call Us to Place an Order for Packages & Accessories
RADIO SYSTEMS WITH RX
FUTK7005 7CHP $ 279.99
FUTK9256 10CHP $ 649.99
FUTK9276 12FG $ 999.99
FUTK9301 12Z $1,499.99
SPM2712 DX7 $ 299.99
JRP2930 X9503 $ 549.99
JRP1210 12X $1,499.99
COLLECTIVE AND CYCLIC SERVOS
FUTM0222 9252 SERVO $ 84.99
FUTM0225 9255 SERVO $ 119.99
JRPS8711 8711 SERVO $ 139.99
JRPS8717 8717 SERVO $ 139.99
JRPS8611A 8611A SERVO $ 124.99
TAIL GYROS
FUTM0808 401 GYRO W/9254 SERVO $ 209.99
FUTM0825 611 GYRO W/9256 SERVO $ 399.99
FUTM0810 520 GYRO $ 149.97
FUTM0809 240 GYRO $ 129.99
DS760 DS760 GYRO $ 155.00
TAIL SERVOS
FUTM0024 9254 SERVO $ 119.99
JRPS8900G DS8900G SERVO $ 139.99
BLADES
6021 MAH 850 BLADES $ 250.00
6023 EDGE FBL BLADES $ 120.00
6026 EDGE FLYBARRED BLADES $ 120.00
6024 MAH 810 BLADES $ 200.00
6025 NHP 800 BLADES $ 140.00
BATTERIES
3000 MAH BATTERY $ 52.99
EDR108 POWR BAKR DUAL BATTERY SYSTEM * $ 130.00
HP35C540006SS HYPERION BATTERIES 5400 MAH 6S $ 229.95
DURALITE BATTERIES PKG FOR TURBINE $ 411.70
STABILIZATION DEVICES **
AP2000I $ 165.00
COPILOT II $ 170.00
HELICOMMAND 3A $ 380.00
HELICOMMAND 3D $ 430.00
HELICOMMAND RIGID $ 480.00
AUTOPILOTS **
HELICOMMAND PROFI $4,500.00
HELICOMMAND PROFI W/GPS $6,710.00
DJI STANDARD $3,200.00
DJI W/WAYPOINT $9,500.00
MICRO PILOT $9,000.00
VIDEO OPTIONS ***
VIDEO DOWNLINK ON 1.3 GHZ $ 430.00
VIDEO DOWNLINK ON 900 MHZ $ 410.00
BUILDING AND TEST FLIGHT FEE (SEE TERMS OF PURCHASE) $1,000.00
* INCLUDES 2 BATTERIES, 2 SWITCHES, AND REGULATOR
** INCLUDES INSTALLATION IF SYSTEM IS PURCHASED THROUGH US AND HELICOPTER IS BEING BUILT BY US.
*** INCLUDES DOWNLINK SYSTEM WITH MONITOR, BATTERIES AND CHARGER | 
